2.8 VOC ACRYLIC ACTIVATOR 700-
SERIES 700
Low VOC Urethane
Single-Stage Custom Color - 2.8 VOC
PRODUCT
DESCRIPTION:
ADVANTAGE #700 Series 2.8 VOC Acrylic Urethane Colors are high
solids, high gloss, low VOC coatings intended for use as a
protective maintenance coating for automotive and industrial
applications, surfaces exposed to humidity, chemicals and
corrosive elements.
Common Uses- Vehicles, Implements & Trailers, Industrial Plants & Mills, Chemical Processing Plants, Refineries, Storage Tanks & Piping, Buildings, Structural Steel & Roof Decks, Marine Vessels & Offshore Structures.
Advantages-Our urethane system may be applied direct to metal and provides excellent exposure protection to severe industrial, commercial and marine environments to maintain it’s exceptional gloss and color retention in the harshest exposures.
DTM:
Bare metal adhesion only in small areas.
NOTE: Performance is better when using primer.
POT LIFE:
Pot life will be about 3-5 hours at 77° F.
MIXING DIRECTIONS (4:1): | |
2.8 VOC |
|
4 PARTS | #700 Series Single Stage |
1 PART | #729 Catalyst |
SURFACE PREPARATION:
1. Wash area thoroughly with soap and water to remove
contaminates that solvent based cleaners cannot remove
effectively.
2. Clean area with Wax and Grease Remover.
3. Use a tack cloth to remove any surface contaminates that may
have settled on the repaired areas prior to paint application.
4. Apply #700 series High Performance Urethane Single Stage
Color.
APPLICATION DIRECTIONS:
Adjust air pressure to 40-50 psi at gun for gravity, siphon feed
guns or HVLP use 6-10 psi at air cap. Apply 2-3 medium coats
(maximum 2 mils wet per coat) or until hiding is achieved. Allow
a 5-15 minute flash time between coats and before force drying.
DRY TIMES AT 77°F: | |
FLASH TIME | 5-15
MINUTES |
TO DELIVER | 16-24 HOURS |
FORCE DRYING AT 140°F: | |
PURGE TIME | 15 MINUTES |
BAKE TIME AT 140°F | 40 MINUTES |
RECOATING:
2.8 VOC ADVANTAGE #700 Urethane Single Stage Color may be
recoated after 16-24 hours at 77°F. After 16-24 hours it must be
lightly sanded/scuffed before additional color or clearcoat may
be applied.
ACCELERATOR & FISHEYE ELIMINATOR:
Accelerator and/or Fisheye Eliminatory is not recommended for
use in this product.
CLEAN-UP:
Clean spray equipment immediately after use with Gun Wash, or a
high quality lacquer thinner, or compliant solvent depending on
area regulations.
TECHNICAL DATA: | ||
Color: Various |
Catalyst: #729 |
|
Weight Solids (RTS): 52 - 70% | Viscosity #2 Zahn (RTS): | 18 - 28 seconds #2 ZahnEazy |
Pot Life: 3-5 hours | Film Build per coat: | 1.0-2.0 mils per full wet coat |
Coverage: 850 sq.ft. per gallon @ 1 dry mil |
Disposal/Safety: | See MSDS for this product |
Part #: ADV.729
Price and Units
Units: 1/2PINT
Units: 1/2PINT Product Links: Sales Flyer Technical Data Sheet Color Card MSDS |
Units: QUART
Units: QUART Product Links: Sales Flyer Technical Data Sheet Color Card MSDS |